M5, L-styli, silicon nitride sphere, stepped, tungsten carbide shaft
With L styli, by default the stylus tip is at a 90° angle to the stylus shaft. Due to their L shape, the styli are particularly well-suited for measuring undercuts in bores. Furthermore, an L stylus can also be used to measure difficult-to-reach points (e.g. on the underside of the workpiece).
Tungsten carbide is the most common shaft material, it combines a very good stiffness with an acceptable thermal expansion. Only the weight can have a negative effect when using large styli. The design of the stepped shaft has the advantage of a greater shaft thickness, which is reduced towards the probe element. This graduation increases the stability of the stylus while maintaining the same length. However, the usable measuring length is reduced as a result. Tungsten carbide shafts represent a good combination in terms of weight, rigidity and thermal expansion.
Silicon nitride styli are just as universally applicable as ruby styli. However, they show less material deposits when scanning aluminum or other soft materials. This does not mean that there iare no deposits here. SiN spheres also shows this problem, the effect only occurs at a later point in time in the process. Due to the almost identical hardness compared to ruby, SiN spheres are equally susceptible to material removal when measuring hard, abrasive materials.
So Sad.
We are sorry. For these criterias we have no products to offer. Try and reset all filters or remove that last filter you set.
Remove last filter